LPC-P2106
[LPC-P2106]

• MCU: 16/32 bit LPC2106 with 128K Bytes Program Flash, 64K Bytes RAM, RTC, 2x UARTs, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
• JTAG connector as per ARM's 2x10 pin layout, ARM-JTAG (Wiggler) compatible
• extension header for uC pins
• 14.7456 Mhz crystal allow easy communication setup (4x PLL = 58,9824 Mhz CPU clock)
• RS232 interface circuit
• RESET circuit
• RESET button
• DEBUG jumper for JTAG enable/disable
• BSL jumper for bootloader enable/disable
• RTCK pullup resistor
• push BUTTON with pullup
• status LED
• Power plug-in jack
• single power supply: +5-9VAC/DC required
• two on board voltage regulators 1.8V and 3.3V with up to 800mA current
• power supply filtering capacitor
• PCB: FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
• prototype PCB area with +3.3V and GND bus
• Dimensions: 100x77 mm (3.9x3.05")
• Four mounting holes

DOCUMENTS:

• LPC-P2106.pdf

• Schematic
• ARM JTAG connector (TOP view)

• BLINK LED at P0.7 - C source code (Rowley's CrossConnect), C source code (IAR EWARM) and compiled HEX code which can be programmed with Philips' Flash ISP utility
• Free RTOS port by Richard Barry for our LPC-P2106 board